C\ Gabiria nº 112-114-146 Pº Ventas
20305 Irún (Guipúzcoa) SPAIN
Tel.: +34 943 633 562 | Fax: +34 943 633 285
E-Mail: conatec@conatec.com
CONATECwww.conatec.com

CONATEC
C\ Gabiria nº 112-114-146
Pº Ventas 20305
Irún (Guipúzcoa) SPAIN
Tel.: +34 943 633 562
Fax: +34 943 633 285
E-Mail: conatec@conatec.com


Cookies

4400

Reguladores PID 4400Temperature regulator set-up by keyboard designed for processes which require actions on contactors, servovalves without feedback and continuous temperature outputs in a small format.

General Characteristics

  • PID or ON/OFF control with adjustable hysteresis.
  • Permanent variable display.
  • LED display the control output action.
  • Input type configurable by keyboard depending on models:
    - Thermocouples J, K, S y B.
    - Pt100 probes, Ni200, Ohms.
    - Analogic signal 0-20 mA, 4-20 mA, 0-10v or 2-10 v.
  • Control action type configurable by keyboard:
    - Relay direct or inverse.
    - Relay for servo-motor without repeater.
    - Analogic 0/20 mA. 0-10v.
    - Analogic 4/20 mA. 2-10v.
  • Absolute, relative or band configurable alarm for the control outputs via relay and analogue.
  • Adjustment of the measurement offset.
  • Output 0/4-20 mA image of the input signal when not using analogue control.

Electric

  • Power supply 230 Vac +/- 10%. Consumption 8 VA.
  • Maximum load for outputs mA with 500 ohm.
  • Maximum consumption for outputs 0/2-10 v with 10 mA.
  • Potential-free relay outputs with cut-off capacity 5A/230Vac in a resistive load.
  • Protection against sensor break.

Mechanical

  • Format 96x96. Panel cut-out 92x44 + 0.8 mm.
  • Depth 140 mm including the connection terminals.
  • Front protection IP54.
  • Rear protection IP20.
  • Operation between 0 and 60ºC and between 0 and 80% of RH.
  • Storage conditions between 10 and 60 ºC.
Attached archives:
Print  Print Send by Email  Send by Email

We use our own and third party cookies, for the analysis of user navigation. If you continue browsing, we consider that you accept the use.
You can change the settings or get more information here.