Regulator completely configurable by keyboard designed for all process types which require actions on contactors, servovalves with and without feedback and continuous outputs.
General Characteristics
PID control with self-tuning or ON-OFF with hysteresis.
Permanent display of the variable and its setpoint.
LED display for the control output action and alarm.
Configuration of the input type for thermocouples J, K, S and B. Pt100 probes, Ni200, ohms and analogue signals 0-20 mA, 4-20 mA, 0-10v or 2-10 v.
Control actions:
- Single-loop relay direct or inverse.
- Double loop relay direct or inverse.
- Double relay for servo-motor with and without feedback.
- Analogic 0/20 mA. 0-10v.
- Analogic 4/20 mA. 2-10v.
Absolute, relative or band configurable alarm.
Adjustment of the measurement offset.
Output 0/4-20 mA image of the input signal when not using analogue control.
Auxiliary power supply for two-wire transmitters.
Input for operating with remote setpoint.
Start – stop station.
Communication to a PC using RS-485 MODBUS RTU.
Electric
Power supply 230 Vac +/- 10%. Consumption 8 VA.
Maximum load for outputs mA with 500 ohm.
Maximum consumption for outputs 0/2-10 v with 10 mA.
Potential-free relay outputs with cut-off capacity 5A/230Vac in a resistive load.
Protection against sensor break.
Mechanical
Format 96x96. Panel cut-out 92x44 + 0.8 mm.
Depth 140 mm including the connection terminals.
Front protection IP54.
Rear protection IP20.
Operation between 0 and 60ºC and between 0 and 80% of RH.
We use our own and third party cookies, for the analysis of user navigation. If you continue browsing, we consider that you accept the use. You can change the settings or get more information here.